| F-4-E has waterproofed over 60,000 basements? |
|
|
GMX ULTRA-SHIELD (below grade) is a multi-layer seamless protective coating which combines an elastomeric waterproofing membrane with a latex-modified cementitious dry mix. GMX ULTRA-SHIELD Below Grade Waterproofing System is used wherever it is necessary to waterproof below grade un-parged block or poured walls, retaining walls, or foundation walls with a system that remains elastomeric indefinitely.
ADVANTAGES
- When FIBREX is used with GMX - Foundations4Energy is proud to offer an incredible 30 year Dry Guarantee!
- Superior waterproofing
- Easy to apply-no special safety apparatus required
- Cost effective-minimal down time
- Highly resistant to fungus/mildew
- Superior bonding
- High impact and abrasion resistance
- Superior freeze/thaw resistance
- Water based-environmentally safe to use and apply
Staying dry and warm…for decades!
FIBREX is a mineral fiber board installed on the below grade foundation walls along with our membrane. This functions as a protection board for our membrane while also providing insulation properties for your basement.
Two FIBREX thicknesses are available: R-5 and R-10
| There are three basic causes for seepage and cracks in basement walls and floors. First, the original workmanship may have been poor. Second, the house may have settled causing cracks to appear in either the floor or walls. Finally, water pressure from the outside may have built up and be forcing water through the walls. |
|
|
Delta-MS is a highly effective waterproofing protection system based on a uniquely formed air-gap membrane. The main component of Delta-MS is the plastic (HDPE) membrane, formed in a dimple pattern to create an air gap at the foundation wall. This
unique design allows any condensation next to the wall to fall freely to the drainage system. Delta-MS is a tough, resilient and durable waterproofing
product. When installed by F-4-E, this product comes with a Limited Lifetime warranty for your Home Owner s comfort and peace of mind.
Trim-Kote is an elastomeric masonry paint that is applied to the above grade block. It’s
main purpose is to prevent moisture from entering the block that may cause dampness on the interior
walls. It comes in foundation gray to give your home a more aesthetic appeal than bare block.
We offer many different masonry sealers to meet any application you may have. Only one application is needed to create a permanent barrier for moisture, thus reducing call backs from your Home Owners. Our Clear Penetrating Sealer can be used on interior or exterior masonry block walls. It is especially formulated to penetrate the pours of the block, crystallize in the block, thus forming a permanent barrier.
This product dries clear and is not affected by ultraviolet rays. Have you ever driven into a sub-division after it rains and see stucco or brick homes that the walls look saturated? Ever wonder what happens
to the water that gets behind your stucco, brick or stone? We have a cost effective solution that
will eliminate your worries. Try our Brick, Stucco and Stone Sealer, once we have applied
our sealer to your home, you will be the only one on the block that the stucco looks the same as it did before it rains.
|
